Hi,
I'm using a hold browser containing multiple active and inactive (through the @N thingy)
lines. It all works as expected when I use the mouse, i.e. inactive lines cannot be
selected. If the browser gets the focus, however, and I use the keyboard to move the
selection up or down the following behaviour is exhibited which I think is wrong:
1 - active
2 - active
3 - inactive
4 - active
5 - inactive
6 - inactive
7 - active
8 - inactive
9 - inactive
Moving down from line 2 skips 3 and goes to 4 as expected, but moving down again skips 5
and _selects_ 6 as opposed to skipping 6 as well. Also moving up from line 7 skips 6 and
selects 5. Finally, moving down from 7 skips 8 and selects 9 when it should do nothing.
Any thoughts?
Mike
-- Dr. Michael K. Steliaros / Comp. Sci. Dept., Warwick University, Systems Programmer / Coventry CV4 7AL, UK. ms@dcs.warwick.ac.uk / Tel: +44 24 76523296, (Fax: 76573024)
_________________________________________________ To unsubscribe, send the message "unsubscribe" to xforms-request@bob.usuhs.mil or see http://bob.usuhs.mil/mailserv/xforms.html XForms Home Page: http://world.std.com/~xforms List Archive: http://bob.usuhs.mil/mailserv/list-archives/
This archive was generated by hypermail 2b29 : Wed Feb 09 2000 - 06:46:08 EST